To provide a mail service, Parallels Plesk Panel supports two mail transfer agents: Postfix and qmail.
Panel uses only one mail transfer agent at a time. You can check which of them is currently enabled on the following page: Server Administration Panel > Tools & Settings > Services Management. You can also do this by running the
mailmng utility located in the
/usr/local/psa for RPM-based systems or
/opt/psa on DEB-based systems:
./mailmng --features | grep SMTP_Server
By default, Panel for Linux uses the Postfix for sending and receiving mail through the SMTP and SMTPS protocols. You can switch to qmail by running the following command:
# /usr/local/psa/admin/sbin/autoinstaller --select-release-current --install-component qmail
To switch to Postfix run the following command:
# /usr/local/psa/admin/sbin/autoinstaller --select-release-current --install-component postfix
Both Postfix and qmail use the same root directory to store incoming mail. This directory is defined by the variable
$PLESK_MAILNAMES_D in the
/etc/psa/psa.conf configuration file. By default, it is
/var/qmail/mailnames. Storing incoming mail in the same directory allows the messages remain available after switching between mail agents.
Unlike incoming mail, the mail queue is lost while switching between the mail agents. Therefore, before switching, we recommend you stop the SMTP service to prevent the acceptance of email and the delivery of all queued mail. To stop the SMTP service, run the following command:
# /usr/local/psa/admin/sbin/mailmng --stop-smtpd
To flush the queue, run the command:
# kill -ALRM `pidof qmail-send`
# postqueue -f
Please send us your feedback on this help page.