Appendix 5. Plesk For Unix Data Mapping Reference
Since Plesk for Unix and Plesk for Windows are very similar control panels, most Plesk For Unix data is migrated to Plesk For Windows without any difficulties. However, there are several exceptions to this rule, which are addressed in this chapter.
For convenience, the information in sections is presented in the form of tables like the one below:
Permissions section
Plesk For Windows parameter
|
Value
|
Origin/Conditions
|
Domain creation
|
Selected
|
default
|
- Each table corresponds to a certain Plesk for Windows page or to a section of options on a page, which name precedes the table (e.g. "Permissions section").
- The Plesk For Windows parameter and the Value/Conditions columns represent the Plesk for WIndows data as it is after the migration (in the form it is displayed in Plesk for Windows user interface): in the Plesk parameter column, parameter names are specified, while the Value column presents exact values of this parameters. In the Value column you find the following parameter values:
- Selected - checkbox corresponding to the parameter is selected
- Selected if - checkbox corresponding to the parameter is selected on the conditions defined in the third column
- Cleared - checkbox corresponding to the parameter is not selected
- Enabled - feature is enabled (in a way differing from selected checkbox)
- Enabled if - feature is enabled on the conditions defined in the third column
- Disabled - feature is disabled (in a way differing from cleared checkbox)
- Equal to - value for a parameter is equal to the value of Plesk for Unix notion(s) defined in the third column
- other values specific for Plesk for Windows parameters
- The Origin/Conditions column provides the information clearing up the contents of the first two columns: either an exact source of a Plesk for Windows parameter value, or a condition under which a parameter possesses the value. You can see there the following:
- name of an exact Plesk for Unix object or parameter.
- default - parameter value is not migrated from Plesk for Unix, but defaults to what is set by Migration Manager.
